New customer?Get $20 OFF your first repairJust mention it when you call · (832) 981-5171
(832) 981-5171Call now(832) 981-5171
Everyday · Newton, Iowa

Maytag Appliance Repair in Houston

Maytag started in Newton, Iowa in 1893 and built its name on dependable washers and dryers. Now part of Whirlpool, Maytag still focuses on heavy-duty laundry, plus refrigerators, dishwashers and ranges. Many Maytag parts are shared with Whirlpool, so the parts are easy to get.

Maytag$20 off first repair
We repair
Refrigerators, Washers, Dryers, Dishwashers, Ovens, ranges & cooktops, Cooktops, Wall ovens
Made by
Whirlpool Corporation
Service area
All of Houston
Warranty
Warranty on every repair
Same-day service available
Maytag refrigerator

Maytag Refrigerator Repair

A Maytag refrigerator that won't hold temperature is more than an inconvenience; it's groceries you might have to throw out. We repair Maytag top-freezer, bottom-freezer, side-by-side and French-door models across Houston, usually the same day you call.

Common Maytag refrigerator problems

  • Fridge is warm but the freezer is cold

    This is the most common refrigerator call we get. Cold air is made in the freezer and blown into the fresh-food side, so when the freezer is fine but the fridge is warm, the air isn't moving. The usual causes are an evaporator fan motor that stopped, a defrost heater or thermostat that failed so the coil iced over, or an air damper stuck closed. We check each one and fix the real cause.

  • Not cooling at all

    When both sections are warm, we look at the parts that make the cold: the condenser fan, the start relay and overload, dirty condenser coils, and the control or inverter board. A failed compressor is less common than people think, and we test it before we ever call it bad.

  • Ice maker stopped

    An ice maker needs water, cold and power. Most of the time the water inlet valve has failed, the fill tube is frozen, or the water filter is clogged. If those check out, the ice maker module itself is replaced.

Maytag washer

Maytag Washer Repair

Laundry piles up fast. When your Maytag washer quits, we read the error code, run the service test and replace the part that actually failed, so you're not paying for guesses.

Common Maytag washer problems

  • Top-load washer won't spin

    Lid lock, shifter or drive components. We confirm the failed part on site before replacing anything.

  • Front-load F8 E1 / F9 E1

    Long fill or long drain, shared with Whirlpool front-loaders. We confirm the failed part on site before replacing anything.

  • Won't drain, water left in the drum

    Standing water usually means the drain pump has failed or is clogged. Socks, coins and lint collect in the pump filter or coin trap, and a kinked drain hose can do the same. We clear it or replace the pump.

Maytag dryer

Maytag Dryer Repair

A Maytag dryer that runs hot or won't heat isn't just annoying; a blocked vent or failed safety part can be a fire risk. We repair gas and electric Maytag dryers and check the vent on every visit.

Common Maytag dryer problems

  • Dryer squeal or thump

    Drum rollers, idler pulley or belt. We confirm the failed part on site before replacing anything.

  • Dryer no heat

    Element, thermal fuse, or gas valve coils. We confirm the failed part on site before replacing anything.

  • Won't start

    A door switch, a blown thermal fuse, the start switch or a broken drive belt can all stop a dryer from starting.

Maytag dishwasher

Maytag Dishwasher Repair

When your Maytag dishwasher starts blinking, beeping or leaving dishes dirty, it's usually a pump, valve, latch or sensor. We test them and replace what failed.

Common Maytag dishwasher problems

  • Dishwasher not cleaning

    Wash pump, spray arms and fill. We confirm the failed part on site before replacing anything.

  • Water standing in the bottom

    A failed drain pump, a clogged filter, a blocked air gap or a new garbage disposal with the knockout plug still in place can all leave water in the tub.

  • Dishes come out dirty

    The wash pump, clogged spray arms or low water fill from the inlet valve are the usual causes. Sometimes the filter just needs a good cleaning.

Maytag oven or range

Maytag Oven & Range Repair

A Maytag range or oven problem usually comes down to igniters, elements, sensors or controls. We diagnose it on site, replace the part and test the oven to temperature before we leave.

Common Maytag oven or range problems

  • Oven won't heat

    On electric ovens, the bake or broil element is the usual cause. On gas ovens, it's usually a weak igniter. The temperature sensor and control board can also stop the oven from heating.

  • Burner won't light or keeps clicking

    A wet or dirty igniter, a failing spark module or a burner switch can cause constant clicking or a burner that won't light.

  • Oven temperature is off

    A failing temperature sensor, a worn door gasket or a calibration offset can make an oven run hot or cold.

Maytag cooktop

Maytag Cooktop Repair

Maytag cooktop problems usually come down to igniters, burner valves, switches or the induction board. We find the failed part and fix it on site.

Common Maytag cooktop problems

  • Burner won't light or keeps clicking

    A wet or dirty igniter, a failing spark module or a burner switch can cause constant clicking or a burner that won't light.

  • Burner flame weak or uneven

    A weak, yellow or uneven flame usually means a clogged burner port, a misaligned burner cap or a gas valve problem. We clean or replace the burner parts and check the gas supply to the cooktop.

  • Induction or glass cooktop element dead

    An element, infinite switch or the induction board can stop one burner from heating.

Maytag wall oven

Maytag Wall Oven Repair

Maytag wall oven problems usually come down to bake or broil elements, the temperature sensor, the door lock or the control board. We diagnose it in your kitchen and test the oven to temperature before we leave.

Common Maytag wall oven problems

  • Oven won't heat

    On electric ovens, the bake or broil element is the usual cause. On gas ovens, it's usually a weak igniter. The temperature sensor and control board can also stop the oven from heating.

  • Oven temperature is off

    A failing temperature sensor, a worn door gasket or a calibration offset can make an oven run hot or cold.

  • Door locked after self-clean

    The door lock motor, lock switch or control board can leave the door stuck locked after a self-clean cycle.

Maytag error codes

What your Maytag is telling you.

Common codes we see in Houston. Exact meanings vary by model, so we confirm on site.

CodeApplianceWhat it usually means
F8E1WasherLong fill: water supply or inlet valve
F9E1WasherLong drain: pump or clog
Our promise

What you can count on.

Same-day service

Call in the morning and we can usually be there today.

Warranty on every repair

Parts and labor are covered. If our repair fails, we come back.

$20 OFF

Your first repair as a new customer. Just ask when you call.

Questions

Maytag repair FAQ

Do you repair Maytag appliances in Houston?

Yes. We repair Maytag refrigerators, washers, dryers, dishwashers, ovens, ranges & cooktops, cooktops, wall ovens anywhere in Houston, usually the same day you call.

Is a Maytag repair covered by a warranty?

Yes. Every repair we do is covered by our parts and labor warranty.

Are you a factory-authorized Maytag service center?

No. Fixmate is an independent repair company, not affiliated with Maytag. We use quality parts, and independent repair is often faster and more affordable.

Same-day service · All of Houston

Maytag acting up? Let's fix it today.

(832) 981-5171Call or text · $20 off your first repair
Call nowText us